Ahresty Techno Service Corporation

Cooling of smal diameter core pins Cooling control of areas in a die where soldering, shrinkage porosity, or pressure leakage tends to occur.
The system is provided with a high pressure cooling pump and an over-cooling prevention control circuit etc.

Attached to the inlet of Jet Cool System, or Water Softener, it removes dirt, sand, slime etc. to prevent clogging of the cooling water channels.

Water softener separates and removes the minerals (calcium, magnesium) which are contained a lot in tap water and industrial water.

Flow watcher is a device to detect and signal the water flow condition of cooling pipe.
Please make full use of Flow Watcher for an early discovery of the cooling troubles as described below by using in combination with an appropriate optional apparatus.

This is the device to monitor and judge the fluctuation of high pressure water flow rate which JECSS discharges.
This is upper―grade model of Flow Watcher, however it makes it possible to comprehend fluctuation of water flow rate.
The trend graph of water flow rate is automatically created and it makes it easier to see the trend of water flow rate.

High-pressure water and air discharged by the
Jet Cool System is branched and concentrated from one pipe to multiple pipes.
※For Jet Cooler

This is a device to visually check the flow of die cooling water.

This is a small diameter cooling tube specially made for Jet Cool System.
The tube can be inserted in a slender core pin, which was formerly not possible.
It can be used effectively for prevention of soldering, pressure leakage and shrinkage porosity.

This is a die cooling tube made of either steel or stainless steel.
For installation, both screw type and O-ring type are available.
The structure is strong against breaking or bending.
Steel tubes are zinc-coated to prevent rusting.
Many variation of hose connecting ports are available.
The head consists of different types to meet all
requirements : head for 2-way channels (F type), head for 1-way channel (L type) and revolving head (H type).

We have various connection parts for cooling tubes.
For the parts not mentioned in this list, please contact us.

To achieve a low price and quick shipment with our original products.
Severe dimensional tolerances are used to prevent leakage and falling-off.
Colors are black, red, blue, yellow, green and semi transparent for easy identification.
To adopt PTFE having excellent heat resistance and pressure resistance.

It consolidates multiple cooling channels mounted on die and connects them simultaneously via a one-touch coupler.

Used to inspect and confirm the cooling water passage inside the die.
Used to inspect and confirm the cooling water passage for the die after the manufacture or maintenance of the die is complete.
Measures the pressure and flow of the cooling water running in the die.
Inspects the leakage of the cooling water passage for the die.

Cooling hoses are gathered on the block fixed on a die, to which a large diameter hose is "one-touch" connected.